This product is no longer available and is replaced by VT-500.
Moving coil and moving magnet phono preamplifier with 5AR4 vacuum tube voltage regulation. Shielded R-Core power transformer, separate step up transformers for MC cartridges, separate inputs for MC or MM cartridges, MM optimized for 47 k ohm load, MC externally adjustable from 10Ω to 47kΩ loads. Fully regulated power supply section, dual triode vacuum tube buffer and gain stages. High gain design with 60 dB overall gain in the MC section. Black or silver anodized aluminum faceplate, black aluminum chassis standard. ZERO feedback design.
The following section describes the PH-302 basic specifications. The specifications are subject to change without notice or obligation.
|Circuit Type||Direct Coupled
Single-ended Class A
|Gain||MM – 38 dB using triode vacuum tubes
MC – 60 dB, using input transformers and triode vacuum tubes
|Noise and Hum||-78 dB below full output|
|Input Impedance||MM – 47kΩ
MC – Selectable 10Ω, 43Ω, 100Ω, 330Ω, 470Ω
|Output Impedance||660 Ohms|
|Frequency Response||RIAA Curve + 0.5 dB, passive RIAA circuit design|
|Power Supply Design/ Power Transformer||Fully Regulated Power Supply with 1 ea. – R-Core transformer, 200% Duty rating for long life and reserve energy|
|Vacuum Tube Complement||2 ea – 6SL7 Head Amp
2 ea – 6SL7 RIAA EQ & Amp Gain Stage and buffer
1 ea – 5AR4 Vacuum Tube Rectifier
|Resistors||1% Metal Film|
|Power Supply Capacitors||6 ea – 47 µFd @ 350 VDC capacitors|
|AC Cord||3 Conductor, Detachable|
|AC Power Requirements||100, 117 or 234 Volts @ 50/60 Hz, set by market|
|Warm-Up Time||5 Minutes|
|Break-In Time||100 hours of playing time|
|Finish||Black or Silver anodized aluminum face plate, semi gloss black aluminum chassis|
|Dimensions||4″ H x 17″ W x 13″ D|